[Llvm-bgq-discuss] lldb

[Biddiscombe, John A.]

Hal,

OK. I recompiled everything of mine over the last few days, and now gdb
refuses to load any debug symbols. I wondered if they were incompatible
and I had inadvertently been picking up the wrong ones before. I’ll try
again and double check all my debug settings

Ta

JB

On 04/03/14 19:15, "Hal Finkel" <hfinkel at anl.gov> wrote:

>John,
>
>I've never tried it, and I don't even know if lldb supports PowerPC in
>general. You can always extract the source and apply the patches from the
>source RPMs and try it. However, you might be stuck with gdb for the time
>being.
>
> -Hal
>
>----- Original Message -----
>> From: "John A. Biddiscombe" <biddisco at cscs.ch>
>> To: llvm-bgq-discuss at lists.alcf.anl.gov
>> Sent: Tuesday, March 4, 2014 12:12:19 PM
>> Subject: [Llvm-bgq-discuss] lldb
>> 
>> Are there any pages out there describing how one sets up lldb to go
>> alongside a bbq clang.
>> I tried building lldb from source, but it wants to know where the
>> llvm source is, and since I’m using the bbq clang I don’t have the
>> source (I wanted to avoid compiling everything from scratch). I
>> wonder if there’s an lldb binary for ppc out there anywhere.
>> (Since I’m targeting Io nodes I’m hoping it’s more feasible to use
>> lldb than it would be on the compute nodes)
>> 
>> Thanks
>> 
>> JB
>> 
>> 
>> _______________________________________________
>> llvm-bgq-discuss mailing list
>> llvm-bgq-discuss at lists.alcf.anl.gov
>> https://lists.alcf.anl.gov/mailman/listinfo/llvm-bgq-discuss
>>